Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLinG Your cHArGEr
It is important to fully assemble your charger before use.
Follow these instructions for easy assembly.
tooLS nEEdEd
Phillips Head Screwdriver
Needle Nose Pliers
inStALL AXLE And WHEELS
1.
Slide the axle (Item 1) through the bottom housing until it
goes through the other side. It should self-align, but may
require some assistance.
2.
Slide a spacer (Item 2) onto each end of the axle.
3.
Slide a wheel (Item 3) onto each end of the axle shaft,
and fasten everything using an E-clip (Item 4) on each
end.
EEBc500-int-Z
inStALL HAndLE
1.
Slide the shaft (Item 5) into one of the handles (Item 6),
followed by sliding each handle into the top base, making
sure the handles guide into the tracks of the legs.
2.
Fasten each handle with a ¼" self-tapping screw (Item 7)
on each side.
3.
Install each cover (item 8) with four self-tapping screws
(Item 9).
4.
Secure the handle using two self-tapping screws (Item
10) to prevent rotation.
For best results from your battery charger, learn to use it
properly. This section tells how to set the controls, charge
a battery in or out of the vehicle, use the ENGINE START
feature, test the battery, test alternator performance, and set
up for flash reprogramming.
7
•
•
Publicité
Table des Matières
