Troubleshooting - Samsung harman/kardon HW-N850 Mode D'emploi

11 TROUBLESHOOTING

Before seeking assistance, check the following.
The unit will not turn on.
Is the power cord plugged into the outlet? ;
Connect the power plug to the outlet.
A function does not work when the button is
pressed.
Is there static electricity in the air?
; Disconnect the power plug and connect it
again.
Sound dropouts occur in BT mode.
; See the Bluetooth connection sections on
pages 12 and 19.
Sound is not produced.
Is the Mute function on?
; Press the (Mute) button to cancel the mute
function.
Is the volume set to minimum? ;
Adjust the Volume.
The remote control does not work.
Are the batteries drained?
; Replace with new batteries. Is the distance
between the remote control and Soundbar
main unit too far?
; Move the remote control closer to the
Soundbar main unit.
The red LED on the subwoofer blinks and the
subwoofer is not producing sound.
This issue can occur if the subwoofer is not
connected to the Soundbar main unit.
; Try to connect your subwoofer again.
(See page 6.)
The subwoofer drones and vibrates
noticeably.
Try to adjust the vibration of your subwoofer.
; Push the WOOFER button on your remote
control up or down to adjust the subwoofer
volume. (to -12, or between -6 ~ +6).
Cannot connect to the TV.
If connected via a wired network
; Check if the cable is connected correctly. (Check
the port name to make sure that the cable is
connected to the correct port.) (See the
corresponding page regarding each
connection method.)
; Press the
of the Soundbar or on the remote control to
check if the mode is correct.
If connected via a wireless network ; Connected
via Bluetooth
1. Switch the Soundbar to "BT PAIRING" mode,
and then use the TV to search again. (See
page 12 for details.)
; Connected via Wi-Fi
1. Check if the TV is a compatible model.
• Only Samsung Smart TVs released after
2013 are supported.
2. Check if the TV is connected to Wi-Fi.
ENG - 34
(Source) button on the top panel