Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MONITORS PROGRAMMING
P
rogramming the Tekna Uno monitors.
Set to ON the SW2-2 configuration dip switch in the door panel, refer to
the instructions manual (T63 /PLUS ML "page 11 " or T500SE ML
2
"page 117") that's enclosed with the door panel.
The door panel will reproduce a tone to advise that the system has
entered into programming mode.
In systems with more than one door panel, the programming process
shall be done on the master door panel only.
To program the monitor from a general door panel (if exist), see the manual T63 /PLUS ML page 11 or
T500SE ML page 120.
Switch off the monitor to be programmed, by pressing the lock
release push button during 1 second.
Once the monitor is off, press the autoswitch-on push button.
While pressing the autoswitch-on push button, press the lock
release push button.
To show that the system is ready for programming, the door
panel will reproduce a tone and the picture will appears on
the monitor. At this moment, the push buttons can be
released. Lift the monitor handset.
M
S
Each apartment must have one master unit only; in case of parallel units configure them as slaves,
both monitors or telephones.
Make a call to check that the monitor has been succesfully programmed.
Repeat these steps to program the rest of monitors.
Once the programming has been finished, set to OFF the programming
switch. If you don't, the door panel will reproduce a sound to advise that the
system is still into programming mode.
4
2
7
Press the door panel push button that will call to
this monitor. At this moment the door panel
and the monitor handset will reproduce a
tone.
With the handset lifted:
If programming the monitor as
, replace
Master
the handset.
If programming it as
, press the door release
Slave
push button, then replace the handset.
21
22
F
unction push button.
During call reception and communication progresses allows the lock release activation, with no
dependence on the handset position.
During stand-by condition and with the handset lifted, allows to call to the master porter's exchange.
T
erminal connector description.
_
HZ-
TELEPHONE DESCRIPTION
D
escription of the T-540 Uno telephone.
b
d
a.
Telephone handset.
a
b.
Speaker grille.
c.
Microphone hole.
c
d.
Subjection hole.
e.
Telephone cord connectors.
e
f.
Function push button.
g.
Hook switch.
f
g
e
door bell push button input.
HZ- :
positive, ground.
– , + :
D :
digital communication.
+
D
A
A :
audio
communication.
Publicité
Table des Matières
