Panasonic NR-BD31ES1 Mode D'emploi page 6

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation
Installing the distance guides
The appliance is supplied with two distance guides which should be
installed on the lower part of the housing to prevent from pushing the
appliance too close to the wall. Appliance may also be installed without
the spacers; however, this may increase power consumption.
Cleaning
After installation, wipe the appliance clean with warm water.
Connecting the mains plug to the household mains socket
After the appliance is plugged, all symbols on the control panel will appear for a moment, and then the startup values will
appear as 5 °C on fridge setting indicator.
Notes:
• Cooling may take longer in the summer months or at other times when the room temperature is higher.
• If you need to unplug the refrigerator, wait at least 10 minutes before you plug it back in again. If not, you might damage
the compressor.
Ambient room temperature
You'll find your refrigerator's climate classification on the rating plate in the left side of the fridge compartment. It shows
the room temperature the appliance is designed to work in.
Climate classification
SN
(Extended Temperate)
N
(Temperate)
ST
(Subtropical)
T
(Tropical)
For saving energy
1. Install the refrigerator in a dry, cool and well-ventilated location. The colder the ambient temperature, the better the
efficiency. (Please refer to Page 5 for dimensions and clearance.)
2. The combination of drawers and shelves that result in the largest in volume and the most efficient use of energy for the
refrigerator.
• Remove the freezer drawers.
• Attach the drawers and shelves in the refrigerator to the positions illustrated on the section of "Parts" (P.7).
3. Do not over fill the refrigerator to allow the air to circulate.
4. Open the doors only when necessary and as briefly as possible.
5. Occasionally clean the ventilation openings at the bottom of the refrigerator with a vacuum cleaner, etc.
(Take care not to damage the refrigerant pipe inside the cover.)
6. When setting to Super Cool Mode, power consumption will be increased.
6 6 6
(continued)
Permitted ambient temperature
+10 °C to 32 °C
+16 °C to 32 °C
+16 °C to 38 °C
+16 °C to 43 °C

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Nr-bd31ew1

Table des Matières