Step 3 - Run The Output Sequence List - Keysight Technologies E36300 Série Guide D'utilisation

Settings Available Key Settings
Trigger Source Key, IO or Rmt
Trigger Delay 0 to 3600 s
1 to 9999
Repeat Count
Continuous -
Step 3 – Run the output sequence list
When Output LIST is initiated, all the List properties cannot be configured, which includes adding or removing
step from the list.
When Step mode transient system is initiated, properties such as voltage mode, current mode, trigger source
and trigger delay cannot be configured.
If both Voltage and Current Mode is set to Fix and Trigger Source is set to Key, pressing Run will automatically
set both voltage and current mode to List and start the list operation.
– Set Voltage Mode to List: Press V Mode Lst .
– Set Current Mode to List: Press I Mode Lst .
– Set Trigger Source to Key. Press Trig Src Key .
– Press the color-coded [On] key to enable the selected output.
– Press Run to start the list operation. To abort the operation, press Stopped .
– Press Back to exit and return to the previous menu.
80
Sets the trigger source for the system.
Default is Key.
Action required:
Press Trig Src to toggle between Key, IO and Rmt.
Key (List Run/Stop Key)
IO (DIO Trigger In)
Rmt (Remote Command)
Sets the trigger delay in seconds.
Default is 0 s.
Sets the list repeat count. This sets the number of times that a list is executed before it
completes.
Default is 1.
Enables check box to repeat the list continuously.
Description
Selects the Run Stopped softkey as a trigger source.
Selects any configured digital IO (with Trigger Input
function) as a trigger source
Selects a remote interface command as a trigger
source.
Keysight E36300 Series User's Guide