Dometic PerfectRoof PR 2000 Instructions De Montage page 14

Installing the awning
Installing the wall bracket
The wall bracket must be installed if the awning is to be attached to the side
of the vehicle when extended.
➤ Select the location of the installation.
➤ Mark where the holes are to be drilled.
➤ At the marked points, drill holes with a diameter of 3 mm from the outside
into the external wall (fig. 5, page 4).
➤ Put the upper and lower sections of the wall bracket together.
➤ Clean the outer sides of the lower section and the installation surface in
the vehicle.
I
NOTE
Make sure that no glue gets on to the movable upper section of
the wall bracket.
➤ To glue and seal, apply an elastic adhesive, such as Sikaflex®-221 for
example, to the back of the wall bracket.
➤ Fasten the wall bracket with drill screws (fig. 5, page 4).
or
➤ Rivet the wall bracket in place (fig. 5, page 4).
Installing the crank bracket
➤ Install the wall bracket for the crank at a suitable location inside the
vehicle (fig. 6, page 5).
Mounting the tensioning arm
Awnings with a width of 4 m to 5.5 m must be secured using a tensioning
arm.
➤ Attach the pre-drilled end of the tensioning arm to the latch for the
tensioning arm using the hexagon head bolt and the hexagon nut with
clamping part (fig. 7, page 6).
➤ Insert the lower section of the tensioning arm into the upper section
(fig. 7, page 6).
14
PR2000, PR2500
EN