Door Closing, Leveling And Alignment - Whirlpool W10417005A Guide De Référence Rapide

DOOR CLOSING, LEVELING AND ALIGNMENT

Dispenser Drips
Ice and water will continue to be dispensed for a few seconds
after you release the dispenser paddle. Wait a few seconds
before removing the glass.
• Flush the water system. Air trapped in the water line will
cause water to continue to flow from the dispenser.
• Check water supply pressure; check Reverse Osmosis (RO)
system if applicable.
• Ice shavings may collect in dispenser chute, and melt, which
causes the dispenser to drip. Clean the ice delivery chute using a warm, damp
cloth. Dry thoroughly.
Door Closing, Leveling and Alignment
If you want the doors to close more easily, or if the
refrigerator seems unsteady, turn the brake feet clockwise
to raise the front of the refrigerator. Turn both brake feet
the same amount to keep the refrigerator level, then
make sure the brake feet are firmly against the floor.
If the doors are uneven at the top, align
the doors. To ensure best alignment,
make adjustments after food has been
stored in the doors.
• Keeping both refrigerator doors
closed, pull out the freezer drawer.
• The alignment screw is inside the
bottom hinge pin of the right-hand
door.
• Insert the ⁄ " hex key wrench (packed
1
8
with the Handle Installation
Instructions) into the bottom hinge pin
until it is fully engaged in the alignment screw.
To raise the door, turn the hex key to the right.
To lower the door, turn the hex key to the left.
• If necessary, continue to turn the alignment screw until the doors are aligned.
Bottom
A
hinge pin
⁄ " Hex key
1
B
8
wrench (provided)
¹⁄₄"
A
Brake foot
5