Package Contents; Installation; Installing The System - Miscea CLASSIC Manuel D'instructions

3.

Package contents

● Refer to fig. B/C for the identification of the package contents.
1. Faucet
2. Water box
3. Soap box
4. Mounting plate for water box (pre-mounted to the water box)
5. Mounting plate for soap box (pre-mounted to the soap box)
6. Power adaptor
7. Set of fasteners and seals
8. Instruction manual
9. Refill Liquids
4.

Installation

!
CAUTION
● Do not open the water box or break the seal of the water box. If you do, the warranty becomes void.
● Do not connect the faucet to a water supply that has no strainer. If you do, the warranty
becomes void.
● Do not install hoses when the faucet is switched on or when the power adaptor is connected.
● Do not hold any object close to the faucet head when the calibration is in progress. This can
block the light and interfere with the calibration.
● Do not install or store the faucet in a location that has the risk of frost damage.
● Be careful with the power cable of the faucet and the soap box. The connector at the end of
each cable is fragile.
● Do not connect the water box of one set to the faucet of another set. There is a possibility that
the system does not function properly.
● Make sure that the hoses for the liquids are correctly connected.
● Do not cut or kink the hoses.
● Only use the supplied materials to install the system.
● Only use the power adaptor supplied with the system.
4.1

Installing the system

!
CAUTION
● Flush the water supply system thoroughly before installing the system. Be sure that the water
supply is absolutely clean.
● Refer to fig. D for the installation of the system. Assemble the system in the given order.
Install a shut-off valve between the water supply and the system. In case of
i
maintenance or repair work to the system, the shut-off valve can be closed and it will
not be necessary to shut off the water supply system.
● Refer to the illustrations for the correct installation of the system.
18