Troubleshooting - Storch Steam Master Mode D'emploi

Reel storage:
These reels have been designed to ensure easy and compact
storage. The power cable and the hose must be unwound
completely before starting to use the machine.
Storing the steamplate:
The handle of the steam plate has been designed to fit bet-
ween the frame and the tank.
Rewinding the power cable:
Insert the plug into the socket-outlet on the side of the reel
and then wind the power cable onto the reel.
Rewinding the hose:
Insert the steamplate end of the hose into the side opening
of the reel and then wind the hose onto the reel.
Slide the steamplate in position whereby the handle is loca-
ted against the tank and the thread is opposite the base
plate.
Tank cap:
Closing the tank cap: Screw the cap onto the filler neck and
tighten it by hand.
Do not over-tighten or cross-thread!
Opening the tank cap: Make sure that the machine is swit-
ched off and that the water is no longer boiling. As a pre-
caution, wait for another 5 minutes until the steam pressure
in the tank has subsided.
CAUTION !
Water vapour is very hot! For your own safety, please wear suitable protective gloves when touching the
tank cap. Keep your face at the maximum possible distance from the machine.
Unscrew the tank cap slowly anticlockwise. Any residual steam left in the tank will now escape; stop unscrewing the
cap and wait until the steam has completely dissipated. You can then unscrew and remove the cap.
An additional flap valve can be found in the filler neck. This valve prevents large quantities of hot water from escaping
if the tank cap is opened too quickly when the machine is still switched on, or if there has been an insufficient cooling
period. The emission of residual hot steam is not prevented by this flap valve.

Troubleshooting

The machine stops heating the water:
− The thermal circuit breaker has been triggered. Switch off the machine, allow it to cool down, refill it with water
and then switch it back on again.
− If the machine still does not work, send it back to our workshop so that we can check the thermal fuse and the ele-
ment. This process should only be conducted by a qualified electrician.
The machine remains in an interrupted state:
Check to make sure the water is above the minimum level and that no additives have been used.
Steam escapes from the tank cap:
Check whether the hose or steamplate are blocked. Clean the seat around the cap.
Original instruction 38