Storch Steam Master Mode D'emploi page 37

Insert the plug into the mains socket-outlet and switch on
the machine. The main switch illuminates when the machi-
ne is switched on.
It takes approx. 18 minutes until the steam has developed
(this depends on the temperature of the water).
Do not leave the machine unattended!
When steam has developed on the steam plate, you can
start work. Before steam is produced, a small amount of
condensate appears on the steam plate.
CAUTION !
Hot water escapes before the steam develops!
When the steam has developed, lift the steamplate above the height of the tank outlet in order to allow condensed
steam to flow through the hose and back into the tank.
If you are right-handed, hold the steamplate in your left hand and place it flat against the wall at the point where you
want to start removing the wallpaper.
Hold the steamplate against the wall for approximately 10
seconds. If you are left-handed, you may find it easier to
work with your other hand.
Run the steam plate to the side of the section you have just
worked on and use a wallpaper scraper to remove the paper
you have just steamed. Working in this manner allows you
to continuously remove wallpaper.
Some wallpaper may require the steamplate to be held
against the wall for a longer period of time, or you may
need to repeat the process if all of the wallpaper has not
been removed.
The machine will operate for around 75 minutes before it
needs to be refilled with water.
The water level is indicated by the glass water level indicator; this should not fall below the minimum level. Switch
off the machine if this level is reached. If you want to continue using the machine, allow it to cool down for at least 2
minutes.
Screw the Pressure Cap (51) onto the filler neck and tighten it by hand. Do not over-tighten or cross-thread!
Refill the tank and proceed as described above.
Never allow the machine to run dry !
This machine is equipped with a thermal safety circuit breaker. If the machine runs dry, this circuit breaker is triggered
and it prevents further use. Switch off the machine and allow it to cool down for at least 2 minutes, then refill it with
water and switch it back on again.
The thermal circuit breaker is reset automatically. If not, allow the machine to cool down for a little while longer. When
you have finished using the machine, allow any residual water to cool and then empty the machine. We recommend
you flush the tank with clean water before storing it away.
Never leave any water in the machine while it is in storage !
37 Original instruction