Installing Your New Appliance - Hisense RF26N1ASE Manuel De L'utilisateur

Installing Your New Appliance

Before using the appliance for the first
time, you should be informed of the
following tips.
Warning!
For proper installation, this refrigerator
must be placed on a level surface of hard
material that is the same height as the rest
of the flooring. This surface should be
strong enough to support a fully loaded
refrigerator.
The rollers, which are not castors, should
be only used for forward or backward
movement. Moving
sideways may damage your floor and the
rollers.
Ventilation of appliance
In order to improve efficiency of
the cooling system and save
energy, it
maintain good ventilation around the
appliance for the dissipation of heat. For
this reason, sufficient clear space should
be available around the refrigerator.
Suggestion: It is advisable for there to be
at least75mm of clearance from the back
of the fridge to the wall, at least 100mmof
clearance from its top, at least 100mm
from its side to the wall and a clear space
in front to allow the doors to open 125°. As
shown in following diagrams.
5
the refrigerator
is necessary to
Note:
This appliance performs well within the
climate class from N to T shown in the
table below. It may not work properly if left
at a temperature above or below the
indicated range for a long period.
Climate class Ambient temperature
SN
N
ST
T
Stand your appliance in a dry place to
avoid high moisture.
Keep the appliance out of direct sunlight,
rain or frost. Stand the appliance away
from heat sources such as stoves, fires or
heaters.
Leveling of appliance
For sufficient leveling and air circulating
in the lower rear section of the appliance,
the bottom feet may need to be adjusted.
You can adjust them manually by hand or
by using a suitable tool.
To allow the doors to self-close, tilt the
top backwards by 10-15mm.
+ 5 0 ℉ t o + 9 0 ℉
+ 6 1 ℉ to + 1 0 0 ℉
+ 6 1 ℉ to + 1 0 0 ℉
+ 6 1 ℉ to + 1 0 9 ℉