Hisense RF26N1ASE Manuel De L'utilisateur page 4

plate.
Make sure that the plug is not squashed
or damaged. Otherwise, it may cause
short circuit, electric shock or overheat
and even cause a fire.
Do not insert the power plug if the socket
is loose, there is a risk of electric shock or
fire.
Switch off the appliance and disconnect
it from the main power before you clean or
move it.
Never unplug the appliance by pulling on
the electrical cord. Always grip the plug
firmly and pull straight out from the socket
to prevent damaging the power cord.
Do not operate the appliance without the
cover of interior lighting.
Any electrical component must be
replaced or repaired by a qualified
electrician or authorized service engineer.
Only genuine replacement parts should be
used.
Do not use electrical appliances such as
ice cream makers inside the food storage
compartments of the appliance unless
they are approved by the manufacturer.
4
To avoid eye injury, do not look direct into
the LED light located in the refrigerator
compartment. If it is not functioning
correctly, consult a qualified, registered
electrician or replace it in accordance with
the "cleaning and care" chapter.
Refrigerant
The refrigerant isobutene (R600a) is
contained within the refrigerant circuit of
the appliance. During transportation and
installation of the appliance, ensure that
none of the components of the refrigerant
circuit becomes damaged.
The refrigerant (R600a) is flammable.
Caution: Risk of Fire
Don't store products which contain
flammable propellants (e.g. spray cans) or
explosive substances in the appliances.
Should the refrigerant circuit be
damaged:
Avoid open flames (candles, lamps
etc.)and sources of ignition.
Thoroughly ventilate the room in which
the appliance is situated.