Hisense RF26N1ASE Manuel De L'utilisateur page 8

In order for the ice maker to operate
properly, a water line is required.
-the maximum inlet water pressure is
700kPa;
-the minimum inlet water pressure is
207kPa.
Warning:
The water connection must be made by a
qualified plumber. Operation outside the
water pressure range may cause
malfunction, severe and damaging water
leaks.
Under normal conditions, a200cc (5.75 oz.)
cup can be filled in about 10 seconds.
If the refrigerator is installed in an area
with low water pressure (below30 psi),you
can install a booster pump to compensate
for the low pressure.
What you need to have before you start
1. Power drill and 1/4'' drill bit.
2. 1/2'' or adjustable wrench.
3.FlatbladeandPhilipshead screwdrivers.
4.You may find these items sold as a kit at
local hardware store.
5. These items are provided with your
fridge. Please check your fridge drawer
to find them.
Connecting to the water supply line
1.First,shut off the main water supply.
8
2.Using the power drill and a 1/4'' drill bit
drill into the cold-water line and connect
the saddle-type shutoff valve.
3.Connect 1/4'' extension tubing to shutoff
valve outlet.
4.Flush the tubing. Turn the main water
supply on and flush out the tubing until the
water is clear. Then, shut the water off at
the water valve after about a quart of
water has flushed through the tubing.
5.Connect the extension tubing line with
the line on the back of the fridge via the
coupler. Fully insert the extension tubing
into the coupler, and then insert the clip
onto the coupler to lockup the tubing. Do
the same with the other end. After both
clips are inserted, check the line to make
sure it is held firmly by the clip.
Note: Ensure that water line does not get
pinched or bent when installing. This can
result in improper water flow through the
line and will affect the functionality of the
fridge.