AEG Voxtel C100 Mode D'emploi page 6

6
6.6 Mute Function
During a call press the mute button
>When the mouthpiece is muted, the person at the other end of the call cannot hear you out you
can hear his side.
To get back to the call, press the mute button
6.7 Use on PBX
If you are using your Voxtel C100 phone on a PBX, and the PBX user guide tells you to press recall or
flash;
Press the recall button
6.8 Inserting a pause in the dialling sequence
For some switchboard systems, an access number must be dialled (usually an 0 or 9) to get another
dial tone and an outside line.
Press the pause button immediately after the access number, a pause of about 3.6 seconds will be
entered, and the desired number can be dialled immediately.
Note:
If you use the , the pause will be included automatically.
Press the pause button to insert a pause when storing numbers in memories, if a pause is required.
6.9 Storing a number in M1-M8 one-touch memories
Lift up the handset, press the store button
Key in the telephone number you wish to store.
>Up to a maximum 32 digits.
Press one of the M1-M8 buttons
>If you try to store more than 32 digits, only the first 32 digits will be saved.
6.10 Storing a number in (0-9) two-touch memories
Lift up the handset, press the store button
Key in the telephone number you wish to store.
>Up to a maximum 32 digits.
Press store button
location.
Replace the handset on the base unit cradle.
6.11 Dial out a one-touch memory number
Lift up the handset, press the M1-M8 button
>The number dials automatically.
6.12 Dial out a (0-9) two-touch memory number
To dial a number stored in a two-touch memory (0-9)
Lift up the handset.
Press the memory button
Key in the memory location number (0-9) for the selected number.
>The number dials automatically.
Warning:
All one-touch, two-touch and redial memories will be erased if the phone is disconnected from the
telephone line for longer than about 2 hours, and they will need to be stored again, if required.
.
on your phone.
-
and then one of the 0-9 buttons to store the number in the selected memory
.
again.
.
to store the number in the selected memory.
.
- for the selected number.