Folding Mechanism; Folding Up The Bicycle Rack; Maintenance And Care; Notes Regarding Environmental Protection - EUFAB CROW PLUS Manuel De L'opérateur

5.6 FOLDING MECHANISM

If you wish to operate the folding mechanism, always hold
the U-shaped bracket or the bicycles with one hand to ensure
that the rack is not able to fold out suddenly. (Risk of injury)
To open the car boot, you may fold the rack down, even if bicycles are
mounted.
With one hand, push down on the unlocking lever of the folding mechanism
(Figure 17), with the other hand, hold the bicycles or the U-shaped bracket.
After unlocking, fold the bicycle rack down carefully.
When folding up, make sure that the mechanism is free and nothing is trap-
ped in it. Make sure that the folding mechanism is fully engaged before
driving o .

5.7 FOLDING UP THE BICYCLE RACK

First fold the wheel rails back onto the rack table. Push the locking mecha-
nism of the rear lights (Position 1 in Figure 18) outwards, and then swivel
the light mount back (Position 2 in Figure 18). Push it rmly against the rack
table until it engages perceptibly. Proceed accordingly on the other side of
the rack.
Figure 18: Folding in the rear lights
In order to store the bicycle rack as atly as possible, you can also fold
the U-shaped bracket down. To do this, undo the two knob nuts until the
U-shaped bracket comes out of the locking mechanism. Now you can fold
the U-shaped bracket down onto the rack table.

6. MAINTENANCE AND CARE

• After use, store the bicycle rack in a clean and dry place. Wash any mud or
other dirt o using water.
• Keep the trailer tow bar clean and free of grease.
• Keep the raack coupling clean and free of grease.
• Check the bicycle rack regularly for damages. Damaged or worn parts must
be replaced immediately. Only original replacement parts may be used.
• Check the bolts and nuts of the bicycle rack regularly and tighten when
necessary.
• Immediately treat any damage to paintwork with paint.
• Regularly lubricate rotating and moving parts.
12
Figure 17: Folding mechanism

7. NOTES REGARDING ENVIRONMENTAL PROTECTION

Due to its lighting system, the bicycle carrier is an electrical
device.
Do not dispose of electrical appliances in household waste!
Discarded electrical and electronic equipment must be col-
lected separately and recycled in an environmentally sound
manner.
Contact your municipal or city government on how to dispose
of old electronic equipment.
The materials are recyclable. You are making an important
contribution to protecting our environment through recycling,
material recycling or other forms of re-utilising old appliances!
Dispose of the bicycle rack in accordance with the laws and
conditions in your country.

8. TIPS AND TRICKS

Plug assignment

• The bicycle carrier is equipped with a lighting system. This is
connected to the socket on the trailer coupling with a 13-pin plug.
• If your vehicle has a 7-pin connection instead of a 13-pin one, the
corresponding assignments are listed below.
• This information is only for the retro tting by a specialised dealer.
A retro tting by non-trained persons is not permitted.
7 Pin
1/L
6/54 2/54G
7/58L
5/58R 3/31
4/R
1/L Turn signal light, left
2/54G Rear fog light
3/31 Earth
4/R Turn signal light, right
5/58R Taillight , right
6/54 Brake light
7/58L Taillight , left
1/L
2/54G 6/54
7/58L
3/31 5/58R
4/R
yellow
blue
white
green
brown
red
black