INFOSEC UPS SYSTEM E3 Performance 5000 RT Notice D'utilisation page 39

batteries. Batteries can be replaced easily without turning the UPS off or disconnecting the
load. If you prefer to remove input power to change the batteries, press the OFF button on
the front panel for two seconds to power off the UPS and switch off utility power where the
UPS is connected.
CAUTION! Consider all warnings, cautions, and notes before replacing batteries.
Note: Upon battery disconnection, equipment is not protected from power outages.

Step 1
Remove front panel.

Step 4
Remove the top cover of
battery box and replace the
inside batteries.

Step 7
INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)240 94 29 51 - hotline@infosec.fr – 12 18 AA 59 205 19

Step 2
Disconnect battery wires.

Step 5
After replacing the
batteries, put the battery
box back to original
location and screw it
tightly.
Put the front panel back to the unit.

Step 3
Pull out the battery box by
removing two screws on the
front panel.

Step 6
Re-connect the battery wires.
39