Brandt MCB5000BT Manuel D'instructions page 15

4.Press MEMORY to store the station into the selected preset number.
5.Repeat the above steps to save all the desired stations.
To listen to a preset station,
Press or or use numeric buttons on the remote control to select a preset station.
There is a FM antenna wire on the back of the unit. Extend and move the wire
around to get the best reception.
FM and FM stereo reception
When the unit is tuned in to a stereo broadcast with a good signal, "ST" will be shown on
the display.
If an FM station is received, but has interference, it is
recommended to switch to MONO mode by pressing
ST/MONO .
Remote control
RADIO OPERATION
EN-13