Wiegand Output; Postal Lock - Chamberlain LiftMaster myQ Business CAPXM Manuel D'installation

INTRODUCTION

Wiegand Output

Disconnect power BEFORE making electrical connections. The CAPXM offers a Wiegand output capable of 26-bit transmission of the
following data:
• Success Call with access granted by the resident. The CAPXM will provide a myQ
Directory Code of the resident that granted access.
And/Or
• Successful access through Entry Code. The CAPXM will provide a myQ
successful Entry Code.
And/Or
• Successful access with a Wiegand credential. The CAPXM will pass along the successful credential Facility Code and ID.

Postal Lock

1. Remove the wing nut and plug. Discard the
wing nut and plug.
2. Remove 4 mounting nuts from studs.
3. Install postal lock using 4 nuts.
4. Cut the factory installed wire tie from the
postal lock switch.
5. The postal lock switch is wired from the
factory.
PRE-INSTALL
Third Party Access System
Wiegand Input
(This Device/Reader Must
be Listed to UL 294.)
INSTALL
Business™ specified facility code followed by the
®
Data-0
Ground
Data-1
DOOR BOARD
21
NETWORK ACCESS CONTROL
Business™ specified facility code followed by the
®