Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
running well.
8.
If the Wood Chipper has not been running (cold engine), warm up the engine by running the engine at half
throttle for 3 to 4 minutes, then advance the engine throttle control to the maximum speed.
STOPPING
1.
Move the Throttle Lever to IDLE.
2.
Recoil Start: Turn the Ignition Switch to the OFF position.
3.
Electric Start: Turn the Key to the OFF position.
OPERATOR ZONE (TOP VIEW)
WOOD CHIPPING
NOTICE
Diameter of wood and branches should be no bigger than 100 mm.
WARNING
Do not place your hands into the chute when loading. This is a very UNSAFE method and could result in injury
to your hands.
Do not reach or step across the rail while the Wood Chipper is running. This is a very UNSAFE method which
could cause personal injury, even death
WHEN BLOCKED
If the Roller stops while chipping woods or branches, the engine should be stopped, and take out the woods
which stuck the roller, and then restart the engine, and chip again.
PART IV: MAINTAINING THE WOOD CHIPPER
Regular maintenance is the way to ensure the best performance and long life of your machine. Please refer to
this manual and the engine manufacturer's user manual for maintenance procedures.
WARNING
A.
FOOT PLATE
B.
ENGINE
C.
INFEED
D.
OPERATOR ZONE
Page 6 of 10
Publicité
Table des Matières
