Conventions Used In This Manual - Power Fist 8893547 Manuel D'utilisateur

WARNING
This indicates a hazardous situation, which, if not avoided, could result in death or serious injury.
CAUTION
This indicates a hazardous situation, which, if not avoided, could result in minor or moderate injury.
NOTICE
This information is important in proper using of your machine. Failure to follow this instruction could result in
damage to your machine or property.
PART I: GENERAL SAFETY RULES
WARNING
Read this Safety & Operating Instructions manual before you use the Wood Chipper.
Become familiar with the operation and service recommendations to ensure the best performance of your machine.
CAUTION
This machine is designed solely to chip wood and must not be used for any other purpose.
It should only be used by trained operators who are familiar with the content of this manual. It is potentially
hazardous to fit or use any parts other than your dealer parts.
BEFORE USING THE WOOD CHIPPER
NOTICE
A. Operators must be fully trained before using this machine.
B. User Manual is read and understood.
C. Machine is positioned on level ground, all guards are fitted and in good condition.
D. Blades are in good condition and secure. All blades are sharpened or replaced in sets.
E. All fasteners are checked for tightness.
F. Only WOODEN materials free of nails etc. are fed into the machine.
G. Fire extinguisher is available on site.
WHEN USING THE WOOD CHIPPER
NOTICE
A. Always feed from the side.
B. It is better to have a second trained operator within easy reach of the machine.
C. Maintain strict discipline at all times and service machine at specified periods.
D. Note direction of discharge chute and if necessary note the wind direction to prevent debris from being blown
into highway or where it could affect members of the public.
E. DO NOT put any part of your body into the infeed chute while the machine is running.
F. DO NOT operate the machine whilst under the influence of alcohol or drugs.
G. DO NOT operate inside a building or confined space or climb on the infeed chute.

CONVENTIONS USED IN THIS MANUAL

Page 2 of 10