Selecting The Main Or Sub Channel-Dual Mono; Setting Bass Sound; Using The Midnight Mode-Midnight Mode - JVC RX-D212B Manuel D'instructions

Masquer les pouces

Table des Matières

Les langues disponibles

Selecting the main or sub channel

—DUAL MONO

You can select the playback sound (channel) you want while

playing digital software recorded (or broadcasted) in Dual Mono

mode (see page 31), which includes two monaural channels

separately. When the receiver detects Dual mono signals, the

DUAL MONO indicator lights up on the display.

D MONO

MAIN

Select to play back the main channel (Ch 1).*

Signal indicator "L" lights up while playing

back this channel.

D MONO

SUB

Select to play back the sub-channel (Ch 2).*

Signal indicator "R" lights up while playing

back this channel.

D MONO

ALL

Select to play back both the main and sub-

channels (Ch 1/Ch 2).*

Signal indicators "L" and "R" light up while

playing back these channels.

Initial setting: D MONO

MAIN

* Dual Mono signals can be heard from the following speakers—L

(left front speaker), R (right front speaker), and C (center

speaker), with respect to the current Surround setting:

Without

Dual Mono

Surround

setting

MAIN

Ch 1

SUB

Ch 2

ALL

Ch 1

Ch 2

NOTE

The Dual Mono format is not identical with bilingual broadcasting

for TV programs. So this setting does not take effect while

watching such bilingual programs.

Setting bass sound

Setting subwoofer output—SUBWOOFER OUT

The subwoofer emits the LFE signals* and the bass elements of

each speaker set to "SML."

You can make the bass elements of the front speaker channels

(MAIN) emitted through the subwoofer.

LFE

Select to emit the LFE signals and the bass

elements of each speaker set to "SML."

LFE+MAIN

Select to emit the bass elements of the front

speakers' channels (MAIN) when no bass

elements are emitted through the subwoofer

in "SW

LFE

Initial setting: SW

LFE

NOTE

• When "SUBWOOFER" is set to "SUBWFR

22), this function is not available.

* The LFE signals are emitted only when playing the following

software with the LFE signals:

– Dolby Digital multi channel software

– DTS multi channel software

When playing analog source or linear PCM software, no LFE

signals are emitted.

With Surround Activated

Center speaker setting

SML/LRG

Ch 1

Ch1

Ch 2

Ch 1+Ch 2

" (see page

Setting the crossover frequency—CROSSOVER

Small speakers cannot reproduce the bass sounds efficiently. If

you use a small speaker in any position, this receiver

automatically reallocates the bass sound elements assigned to

the small speaker to the large speakers.

To use this function properly, set this crossover frequency level

according to the size of the small speaker connected.

• If you have selected "LRG (large)" for all speakers (see page

22), this function will not take effect ("CROSS OFF" appears).

CROSS

80Hz