FUXON 051-20135 Mode D'emploi page 3

Parts List:
1 Fitting Adjustor
2 Screw
3 Nut
4 Clamp
5 Height Adjusting Cylinder
4 4
Steps:
1. Please find scales on the adjusting cylinder fit carrier on your bike after choosing suitable
scales, screw it up.
2. a) Insert four screws from above through four elliptical holes.
b) Insert two fitting adjustors, adjust the position and tighten the nut.
c) Fit adjustors at the frame or use two clamps to fit the fitting adjustors if the frame has no
threads at the upper end of the seat stay.
3. Please note the fitting adjustors could be adjusted by left & right up & down or
back & forth. After find the perfect position please screw the fitting adjustors and clamps
up carefully.
ATTENTION: Continually check tight set of all bolts!
Note to the maximum load weight of 25 kg.
2 2
1 1
3 3
5
MANUAL FOR CARRIER
GB