Layout; Initial Setup; Preparation; Assembly - CEMO SW 200 Manuel D'utilisation

5. Layout

The layout is presented on the basis of the SW 200
and differs from the type SW 300 only in the shape
of the hopper attachment.
22
15
2
3
4
8
5
Figure 5.1.1: Spreader SW 200
a Frame, complete
b Drawbar, complete
c Handle
d Wheel, complete
e Wheel shutoff, left
f Wheel shutoff, right (covered)
g Wheel bearing (both sides)
h Axle with bearing (covered by axle boot)
 Axle boot
 Gearbox with aluminium housing, complete
 Shaft coupling
 Vertical axle for agitator (covered)
 Spreader disc,
adjustable
 Vertical axle
bearing
 Pusher, complete
 Spreader guard
 Agitator
 Basic hopper
 Anti-compaction panel
 Hopper attachment
Lighting, complete
22
9 10 11 12
19
17
Figure 5.1.2:
Inside of base hopper

6. Initial setup

6.1 Preparation

Remove the preassembled assemblies and all indi-
vidual parts from the packaging and lay them out
clearly on a level, clean floor.
20 Assembly tools:
• Spanner SW: 8, 10, 13, 19.
18 • Side cutter.

6.2 Assembly

1

6.2.1 Drawbar with drawbar eye /

ball head coupling (optional)

16
1. Loosely mount the drawbar to the frame and
handle with screws A.
6
13
14
A
7
Figure 6.2.1.1: Assembly of drawbar complete
2. Hang spreader onto towing vehicle by means of
drawbar eye (optional: ball head coupling).
C
Figure 6.2.1.2: Screw C
3. Align the spreader horizontally by positioning
screw C in the holes in the handle.
4. Align the spreader horizontally by positioning
screw D in the holes in the drawbar eye.
5.Tighten all screwed connections.
GB
A
D
Figure 6.2.1.3: Screw D
17