Operation Instruction; Load And Unload The Fuel Cell; Load And Unload The Fastener; Depth Of Drive Adjustment - Alsafix D 90 G1 Manuel D'utilisation

Load and unload the fuel cell :

- Open the fuel cell door by pulling the door and rotate.
- Insert the fuel cell into the chamber. Align the fuel cell nozzle to the fuel stem on the tool.
- Clode the fuel cell door.

Load and unload the fastener :

- Connect to battery and fuel cell before you load the fasteners. The tool had the chance to cycle
once when connected to the battery. If you load the fastener before the battery connected, the fas-
tener may be shoot out accidentally.
- Point the nozzle away from any personnel and keep your finger out of trigger when loading the
festener.
- To load the nail, slide in the nail strip into the magazine until the nail strip passed the nail stopper.
- Pull the pusher until it is beyond the stopper.
- Release the pusher to engage the nail strip and feed in into the nozzle.
- To unload the fastener from the magazine, press the release lever on the pusher and tilt the tool
to slide the nail strip to the rear end of the magazine
- Unload the nail strip by press the nail stopper and slide out the nail strip.

Depth of drive adjustment :

- This tool is equipped with tool free depth of drive adjustment. Test the depth of drive on scrap
piece before you start your work.
- Turn the knob to adjust the depth of drive.
- Repeat above procedure until you find your desired depth of drives setting.

Actuate method and the steps to fire the tool :

- This tool is equipped with single sequential trigger system only.
- To actuate the tool, depress the safety against the work piece, and then pull the trigger.
- To actuate the tool again, you will need to release the safety fully and release the trigger before
you repeat above procedure.
- Make sure you are driving against work piece before you pull the trigger.
Jam clearing :
- In the case of nail jam, disconnect the power source (fuel cell and battery) before you perform any
action.
- Use a #2 Phillips screw driver to insert into the drive channel.
- Tap the screw driver with a hammer to push back the driver blade and release the jam.
- Remove the jammed nail with needle nose pliers or similar type of tool. Do not use your hand to
remove the nail.
- If you failed to remove the jammed nail by above method, remove the magazine by un-thread the
connecting bolt and remove the Jammed nail with needle nose pliers. Assemble the magazine back
before further use.

Charge the battery and LED on tool and charger :

- There is battery comes along with the tool. It will take 2 hours before the new battery can be fully
charged.
- There will be no LED light when the charger is connected to electric and no battery is on the char-
ger.
- The LED on the charger will turn red when it is charging a battery.
- The other LED will turn green when the battery is fully charged.
- In the case of battery failure, the red and green LED will blink in sequence.
- When the tool is connected to a charged battery, the LED indicator on the tool will turn green.
- If the tool is running out of battery, the indicator LED will turn red. When the LED indicator turns
red. When the LED indicator turns red, stop using the tool and replace the battery.
Warning : disconnect the power source (fuel cell and battery) before performing any maintenance
2. OPERATION INSTRUCTION
11