Automatic Operating Mode; How To Activate The Automatic Mode - Haverland RC 4 ECO Manuel D'instructions

4º
Use the "+ / -" keys to select the type of operation you require.
You can choose between:
Presence Sensor enabled.
Presence Sensor disabled.
5º
Once you have selected the operating mode, press "OK" to accept your
choice and the heater will return to the Automatic or Comfort mode (if
this mode is programmed) and the current heater status will be displayed
on the screen.
In order to take advantage of the new heating feature, we recommend
that you always use this operating mode. You should keep the thermal
fluid heater with the presence sensor enabled so that you can reduce the
power consumption of your heater in function of the programmed Comfort
temperature.
IMPORTANT NOTE:
The "Presence Sensor" is only activated when you select either the
Comfort or
Automatic mode (within the programmed Comfort periods).
This option is not available in any other operating mode.
1- SENSOR ENABLED
1.1 DETECTING PRESENCE.
1.2. NO PRESENCE DETECTION.
2- SENSOR DISABLED

10.9 Automatic Operating Mode

One of the main functions of your Eco-Sensor heater is the Automatic mode,
which makes it possible for you to program your heater with various time sche-
dules depending on your own needs.
You have a daily programmer to select the program that is best suited to your
needs from among the NINE STANDARD PROGRAMS (P1 toP9), or to set up
your own made-to-measure plan using the FOUR CONFIGURABLE PRO-
GRAMS (U1 to U4).
You are control at all times of the ideal temperature for each day.
SEE PAGE 37 "ADVANTAGES OF THE HEATER WITH PRESENCE CON-
TROL"
The Eco-Sensor thermal fluid heater executes the selected program according
to the time. You program the Comfort and Economic temperatures (see section
"Comfort and Economic Operating Modes on Page 39-40).
A) How to activate the Automatic mode.
1º
Press the "OK" key for at least two seconds to access the functions
menu.
2º
Use the keys to position the function selector cursor
Automatic symbol (Note 8).
Note 8
3º
The screen will display the following information:
- The function selector cursor is positioned over Automatic mode.
- The current programmed temperature (22 ºC).
- The current time and day of the week (08:00 am and Wednesday
"3").
- If the flame symbol is shown (as in the example) then the heater is
in operation (the programmed temperature is higher than the room
temperature).
- The currently enabled program description (00:00 to 07:00, econo
mic temperature; from 07:00 to 10:00, comfort temperature and
from 10:00 to 12:00, economic temperature).
4º
Press "OK" to accept the Automatic mode.
5º
The screen will display:
Automatic mode
heater
operating
Room
temperature
Day of the
week
PAG. 43
over the
Sensor enabled
and detecting
Clock
Program
description