Packing List - Ego Power+ RTX2300 Mode D'emploi

◾
The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another;
◾
The declared vibration total value may also be used in
a preliminary assessment of exposure.
NOTICE:
The vibration emission during actual use of the
power tool can differ from the declared value in which the
tool is used; In order to protect the operator, user should
wear gloves and ear protectors in the actual conditions of
use.
DESCRIPTION
KNOW YOUR ROTOCUT (Fig. A)
1. Sealing Screw
2. Gear Case
3. Blade
4. Blade Sheath
5. Guard Assembly
6. Wrench
7. Allen Key
8. Bush (For using with 25mm diameter tube)

PACKING LIST

PART NAME
ROTOCUT
Guard Assembly
Wrench
Allen Key
Bush
Operator's Manual
ASSEMBLY
WARNING:
If any parts are damaged or missing, do
not operate this product until the parts are replaced. Use of
this product with damaged or missing parts could result in
serious personal injury.
WARNING:
Do not attempt to modify this product
or create accessories not recommended for use with this
machine. Any such alteration or modification is misuse and
could result in a hazardous condition leading to possible
serious personal injury.
WARNING:
cause serious personal injury, always unplug the battery
connector from the socket when assembling parts.
REPLACE THE TRIMMER HEAD WITH ROTOCUT HEAD
1. Hold your line trimmer/brush cutter and use the allen
key to remove trimmer guard, trimmer head and gear
case from the drive shaft (Fig. B1-B3 ). The drive shaft
will be used for assembly of the ROTOCUT later.
2. Remove the ROTOCUT from its packaging, loosen the
two Screw 1# and hold them on the fixing plate, loosen
and remove the Screw 2# from the fixing plate. (Fig. B4)
B-1 Screw 1#
B-3 The fixing plate
3. Insert the ROTOCUT head onto the drive shaft removed in
step 1, make sure the hole of B-2 screw is aligned with
the hole on the drive shaft (Fig. B5).
4. Insert the B-2 screw first and tighten it, and then
tighten the two screws of B-1 (Fig. B6).
5. Remove the ROTOCUT guard from its packaging
and loosen the two bolts in the guard. Remove and
reserve the two bolts and spring washers from the
guard (Fig. B7).
QUANTITY
6. Lift the ROTOCUT head and face it downward; align
the two mounting holes in the guard with the two
1
assembly holes in the ROTOCUT fixing plate. Make
1
sure the guard direction is as the picture below, the
arc shape around the cutting teeth. (Fig. B8).
1
7. Use the allen key to lock the guard in place.
1
8. Remove the blade sheath from the blade during
1
operation.
1
OPERATION
WARNING:
to make you careless. Remember that a careless fraction of
a second is sufficient to inflict serious injury.
WARNING:
hearing protection. Failure to do so could result in objects
being thrown into your eyes and other possible serious
injuries.
WARNING:
accessories not recommended by the manufacturer of
this product. The use of attachments or accessories not
recommended can result in serious personal injury.
ROTOCUT — RTX2300
To prevent accidental starting that could
B-2 Screw 2#
Do not allow familiarity with this product
Always wear eye protection, along with
Do not use any attachments or
EN
7