Selecting The Unit - Adam CPWplus Série Mode D'emploi

EN
• Zero the scale by pressing the [Tare/ Zero] key if necessary.
The zero indicator will be on.
• Place a container on the platform, a value for its weight will
be displayed.
• Press the [Tare/Zero] key to tare the scale. The weight that
was displayed is stored as the tare value. This value is
subtracted from the display, leaving zero on the display. The
indicator "Net" will be on.
• As a product is added to the container, only the weight of the
product will be shown. The scale could be tared a second
time if another type of product was to be added to the first
one. Again only the weight of the product that is added after
taring will be displayed.
• When the container is removed a negative value will be
shown. If the scale was tared just before removing the
container, this value is the gross weight of the container plus
all products. The zero indicator will also be on because the
platform is back to the same condition as it was when the
[Tare/Zero] key was pressed last.
Note: If the capacity of the scale is 6000g and a container
weighing 2450g is used and tared, the scale can then be
used to weigh the material of up to 3550g.

10.4 SELECTING THE UNIT

© Adam Equipment Company 2014 11 9009RevD1-Jul14