Operations; Switching On The Scale; Zeroing; Taring - Adam CPWplus Série Mode D'emploi

EN

10.0 OPERATIONS

10.1 SWITCHING ON THE SCALE

• To switch on the scale, press the [On/Off] key.
• The display will show the software revision number and then
flash all the digits and symbols before counting down to zero.
This ensures all LCD segments are working. The last active
weighing unit will be displayed.
• The scale will turn off automatically to conserve battery life if
the automatic turn off parameter is set (see section 13.1.1).
To turn off the scale press the [On/Off] key.
• A battery symbol will be on when the internal battery needs
to be re-charged. Connect the power supply module to the
rear of the indicator and switch on the mains.

10.2 ZEROING

• The ZERO and TARE function is combined into one key
[Tare/Zero].
• You can press the [Tare/Zero] key at any time to set a new
zero point. Re-zeroing the scale may be necessary if a small
amount of weight is still shown when the platform is empty.
• If the scale is less than 2% of the maximum capacity,
pressing [Tare/Zero] will zero the scale. However, if the
weight on the scale is more than 2%, pressing [Tare/Zero]
will tare the scale. See the next section on taring the scale.
• The scale has an automatic zero tracking function to account
for shifting of the zero point due to the environment change
or accumulation of dust on the platform.

10.3 TARING

© Adam Equipment Company 2014 10 9009RevD1-Jul14