INVENTOR ΑΤΜ-25L Manuel D'utilisateur page 5

Disconnect the device, if abnormal sounds, odors or smoke occur.
l
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
l
similarly qualified persons to avoid a hazard. Never attempt to dismantle, repair or modify
the device.
Do not attempt to repair, dismantle or modify this appliance. Contact your authorized
l
service technician for repair or maintenance of this device.
Do not operate or stop the unit by switching the power supply on or off.
l
Do not insert any objects in the unit's air inlet and exhaust as this may cause damage to the
l
device.
Do not place heavy objects on the power cord. Make sure that the cord is not compressed.
l
Do not place cord under any obstacles (carpets rugs or runners etc). Cord should be
l
arranged away from areas where accidental tripping may occur.
Casters should be able to move comfortably over any obstacle. Be extra cautious while
l
moving over carpets, since any extra force may cause the tipping of the unit, or the spilling of
any water collected in the bucket.
Do not sit or climb on the device.
l
Do not place the unit in direct sunlight or near other heating sources.
l
Do not use the unit near heat sources, chemicals, radiators, flammable materials or fire.
l
Do not remove the water tank while the device is in use.
l
Do not use the device without the filter. Dirt and lint may clog the unit thus reducing
l
performance.
Do not drink or use the collected water of the unit for any purpose.
l
Do not use the unit with wet hands.
l
EN
Upon first use, and for proper calibration, please
allow unit to operate continuously for 24 hours.
5