Remote Control - Tivoli Audio 10+ Mode D'emploi

5. R-SPR: Connect the male RCA cable from the optional Tivoli Audio Model 10 Speaker to
this female RCA output. Make sure the Stereo/Mono setting is set to Stereo by pressing the
Mono button on the remote control and be sure the display shows "ST" for stereo and not
"M" for mono.
6. SUB OUT: Connect the audio cable from the optional Tivoli Audio Model Subwoofer (or other
compatible subwoofer) to this output. This jack accepts a 3.5mm stereo male mini connector.
7. REC OUT: Connect a cassette deck's audio input (or other recording device) to this fixed level
stereo output to record the audio. The primary speaker will not be muted when using this
output. This jack accepts a 3.5mm stereo male mini connector.
8. MIX IN: Connect the audio output of another device, such as a computer, to this input to hear
the audio mixed in with the tuner. With the Model 10+ in Auxiliary mode, this input acts as a
second Auxiliary input. This stereo input accepts a 3.5mm stereo male mini connector. The vol-
ume level is controlled by the source device.
9. AUX IN: To hear audio from another device, such as Tivoli Audio's Model CD, a MP3 player, or
TV, connect said device's audio output to this stereo input and change the source to Auxiliary.
This stereo input accepts a 3.5mm stereo male mini connector. Note you may need to adjust
the volume level differently for an auxiliary device than the level used for radio listening.
10. SERVICE: The port underneath this label is for use during service only. Do not remove the
"Service" label. Do not connect anything to this port or you could damage the Model 10+ and
void your warranty.
GUIDE TO FEATURES (REMOTE CONTROL)
1. POWER: Press briefly to power the Mod-
el 10+ off or on. The radio will power on
to the last source used.
2. MUTE/SNOOZE: Press to mute the audio
(the volume bars will disappear from the
icon) while the unit is playing; press again
or adjust the volume to restore sound.
Press to mute the alarm for 7 minutes
after the alarm sounds. A
show on the display when Snooze is ac-
tive. The Snooze time is not adjustable.
3. ALARM: With the Model 10+ powered on,
use the pq and Select buttons to adjust
and set the alarms. For a complete step-
by-step guide, refer to the section titled
"How to set the Alarm."
4. SLEEP: Press repeatedly to view the
amount of time the radio will play before
it turns off automatically, and press the
Select button to select that time. When
the sleep timer is active you can check the remaining time by means of pressing Sleep on
remote. A small clock face [
cancel Sleep, press the Sleep button until the display shows "Off".
5. SOURCE: Press repeatedly to change sources.
6. INFO: Press repeatedly to cycle through the information available depending on the source
9 – ENGLISH
4
2
3
12
icon will
11
8
] will show on the display when the Sleep timer is active. To
BAC K
MONO
5
1
6
7
9
13
10