How To Set Alarm - Tivoli Audio 10+ Mode D'emploi

defaults and cancel all your personal settings, such as presets and language. Also see the
section marked "Digital Radio/FM Reception".
8. ID (FOUND UNDER SETTINGS): Press Select to view the ID. If you contact your dealer or
Tivoli Audio with a question, you may be asked to provide the number shown in this field.
9. SLEEP (FOUND UNDER SETTINGS): Press Select and use pq and the Select buttons to
set the sleep timer to one of the available times. There is also a dedicated Sleep button on the
remote control. A small clock face will show on the display when the Sleep timer is active.
HOW TO SET THE ALARM
1. With the Model 10+ powered on, Access the alarm setting either through the main menu or by
pressing the alarm button on the remote.
2. Alarm 1 is shown first. Press the Alarm button repeatedly or use the pq and Select buttons
to choose between Alarm 1 and Alarm 2. Note: At any point you can navigate through the alarm
menu by using the Back or left arrow buttons, and the Select or right arrow buttons.
3. Use the pq and Select buttons to set the alarm on or off. If the time and date are not set
the Model 10+ will prompt you to set Time/Date. Otherwise, set the alarm as described in the
next step.
4. Use the pq buttons to set/change the hour, then press Select. Repeat this process to set/
change the minutes, followed by AM/PM (if time is set to 12 hour format), then press Select.
5. Use the pq buttons to select how long you want the alarm to sound, then press Select.
6. Use the pq buttons to select the source you wish to wake to, then press Select. If you set
the source to DAB (includes DAB+/DMB) or FM, use the pq buttons to select the station pre-
set (if presets have been stored) or last listened, then press Select.
7. Use the pq buttons to set how often the alarm should be set to wake, then press Select.
If "Once" is selected, you must set the date you wish the one time alarm to sound.
8. Lastly, use the pq buttons to set the volume level of the alarm, then press Select.
9. Repeat this process for Alarm 2 if desired.
If you make a mistake at any point in the process, press the Back button on the remote and
begin again.
Note: Your settings will not be saved unless you complete the entire process and the display
shows "Alarm Saved".
Note: If you set the alarm source to DAB and the last listened or preset station is unavailable at
the time the alarm sounds, the alarm will default to the tone.
Power Loss: Should power be lost, or the Model 10+ becomes disconnected, the alarm time
will be saved but the Model 10+ alarm cannot sound if there is no power.
Alarm Quick Set: With the Model 10+ in standby, repeatedly press the alarm button briefly to
toggle each alarm on or off.
12 – ENGLISH