Menu And Specific Features - Tivoli Audio 10+ Mode D'emploi

mode you are in. This function will not work in Auxiliary mode.
7. PRESETS 1-5: Press and hold to store the currently tuned station. Press briefly to recall the
station associated with that specific preset. In FM mode, the preset number will be indicated
on the display. There are 5 presets for each band.
8. VOLUME +/–: Press the Volume + button to raise the volume level or the Volume – button to
lower the volume level. If the audio ever sounds distorted, lower the volume level to avoid dam-
aging the speaker. Adjusting the volume while the Model 10+ is muted will cancel the muting.
9. pq/TUNE +/-: Press to adjust menu items. Use these same buttons to manually tune up or
down when in FM mode. A "T" will show on the display to indicate manual tuning mode. Press
and hold to move quickly through the frequencies. It will take a second until the frequencies
begin to change. Press for 1.5 seconds and release to auto scan to the next station detected.
The display will show "Scanning..." Also refer to "Scan Setting" under the section "Menu
and Specific Features". In DAB mode, use the pq buttons on the remote, or press the Multi-
Function Control Wheel on top of the unit, to show all available DAB/DAB+/DMB stations. Use
the pq buttons or the top control wheel to highlight specific stations. The Station list will
disappear between 7 and 15 seconds depending on whether it was accessed via the Control
Wheel or the remote control.
10. t u: The right arrow button duplicates the Select button. The left arrow button moves you to
the previous page in certain menu items.
11. MENU/SELECT: Press and hold to enter the main menu and press briefly to select items
within the menu. For more, see the section marked "Menu".
12. BACK: Press to go back to the previous menu page.
13. MONO: Press to change the Stereo/Mono setting. The display will show "M" for mono or
"ST" for stereo. "Mono" or "Stereo" will also be one of the fields shown when pressing the
Info button on the remote in FM mode. This setting also affects the headphone output. For
more, see the section marked "Digital Radio/FM Reception".

MENU AND SPECIFIC FEATURES

Press and hold the Menu/Select button on the remote to enter the main menu. Use the pq
buttons and the Select button to change the items within the menu. Use the Back button to
navigate back, or wait for 15 seconds until the timeout expires.
An asterics (*) indicates the shown menu item is currently set.
1. SCAN SETTING (FM MODE ONLY): Press the Select button and use pq and Select button
to choose between "Strong stations only" or "All stations" when performing an auto scan (see
#9 (pq/Tune +/-) under "Remote Control". Selecting "All stations" increases the sensitivity of
the scan, possibly resulting in the auto seek stopping on noise. This feature is not accessible
in Auxiliary mode.
2. TIVOLI EQ: Press the Select button and use pq and Select buttons to adjust the Bass and
Treble. The adjusted values will be shown in "User EQ". Press the Select button to turn
Loudness On or Off. Turning Loudness on when listening at low volume levels is recommended
since it boosts high and low frequencies resulting in a more natural sound. Use pq and Select
buttons to activate any one of the pre-set EQ settings. Selecting a preset EQ will over-ride
any adjustment made to the Bass and Treble settings, but Loudness will be unaffected. The
"Flat" EQ restores the audio settings to the factory defaults, meaning Bass and Treble will be
re-set to zero. The "Flat" EQ also restores Loudness Off. However, if the Bass and Treble had
been adjusted, those settings will still be shown in "User EQ". Simply selecting "User EQ" will
10 – ENGLISH