Rear Panel Controls - Tivoli Audio 10+ Mode D'emploi

cancel the snooze.
2. LCD:
: Volume level
: Sleep timer
: Snooze timer
: Alarms 1 and 2
GUIDE TO FEATURES (REAR PANEL)
1. 12VDC/1500mA: Use this input to op-
erate the Model 10+ using its included
external power supply. Use only the
power supply provided with this prod-
uct. Should the power supply become
damaged or misplaced, use only a like
replacement. Any DC adapter used
must meet the requirements of EN/IEC
60065 and be rated at 12VDC 1500mA
and 230V 50Hz (depending on your re-
gion's power requirements). Use of any
DC adapter not recommended by the
manufacturer/not meeting this specifi-
cation may cause a safety hazard. The
connector is 5.5mm/2.1mm center posi-
tive. It is normal for the power supply to
become warm during use.
2. EXTERNAL ANTENNA: An external telescoping antenna is affixed to this input and is not
intended to be detached. Adjust for best reception. For more, see the section marked "Digital
Radio/FM Reception".
3. HEADPHONE OUT: Connect a headset (not included) to this variable stereo output for private
listening. The headset will mute the primary speaker. The headset's volume is adjusted using
the control wheel or the remote control. The remote's "Mono" button also affects this output.
This stereo out-put accepts a 3.5mm stereo male mini connector. Avoid using headphones
at high volume levels to prevent possible hearing damage.
4. PRESETS 1-5: Press and hold to store the currently tuned station. Press briefly to recall the
station associated with that specific preset. In FM mode, the preset number will be indicated
on the display. There are 5 presets for each band.
8 – ENGLISH
(center digits): Time
: Reception level
DAB: DAB/DAB+/DMB band
FM: FM band
10
3
2
5
1
AUX: Auxiliary
ST: Stereo
M: Mono
T: Manual tuning mode
4
8
9
7
6