Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1
EN
Use the tool at the designated grip points.
Use the recommended reaction devices. For torques,
see tool instruction manual.
After powering the controller on, wait until the boot
cycle is completed, approximately 60 seconds, before
powering it down again.
During Maintenance
The controller is generally maintenance-free.
Consider local regulations for maintenance and servic-
ing for all operating phases of the tightening system.
When Cleaning
Only clean the exterior of the tool using a dry or slightly
damp cloth.
Do not immerse the controller or tools in any liquids.
Do not use a high pressure cleaner.
At The Repair
Repairs to the equipment are not permitted.
Send the controller to a Authorized
Cleco Production Tools Sales & Service Center.
At Disposal
Components of the tightening system present potential
risks to health and the environment. The tightening system
contains components that can be recycled, as well as com-
ponents that have specific disposal requirements.
Follow local applicable regulations.
First separate, then dispose of components.
Collect auxiliary materials (oils, greases) when drain-
ing and dispose of them properly.
Separate the components of the packaging and dis-
pose of them according to local regulations.
Return defective equipment to an approved collection
point or return it to the Sales & Service Center.
Observe local regulations for disposal of
electronics and batteries. (In Germany,
the Electrical and Electronic Equipment
Act (ElektroG) and the Battery Act
(BattG)):
Used up batteries must be disposed
8
of properly. Return depleted or defec-
tive batteries to an approved collec-
tion facility or to Sales & Service
Center for recycling.
P2300HW | 2019-03
Apex Tool Group
Publicité
Table des Matières
