Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1
Notes on this Description
This description is intended to provide setup and use
instructions for the Controllers:
mPro400GCD-P.
Software instructions are provided in separate program-
ming manuals based upon the version installed.
The original language of this document is German.
Minimum Software Requirements
No.
Description
S168813
Standard Controller Software
V1.8.0
S168677
mProRemote – Interface software between
an external computer and controller
Reference Documents
No.
Document type
P1730E
Reference Handbook
Fastening Sequences
P2361JH
Quick Installation Guide Global Controller
P2280PM
Programming Manual
mPro400GC Standard SW
P3268C
EC Declaration of Conformity mPro400GCD-P
Symbols in the text
Italic
Identifies menu options), input fields, control
boxes, options fields or dropdown menus.
>
Denotes the selection of a menu option from
a menu, e.g. File > Print
<...>
Denotes switches, pushbuttons or keys of an
external keyboard, e.g. <F5>
Courier Denotes filenames and paths, e.g.
setup.exe
•
Denotes lists, level 1
-
Denotes lists, level 2
a)
Denotes options
b)
→
Denotes results
1.
(...)
Denotes action steps in sequence
2.
(...)
Denotes a single action step
Sales &
Cleco Production Tools – Sales & Service
Service
Centers, see last page.
Center
Apex Tool Group
2
Safety
2.1 General Requirements
Only operate the controller after you have read and
fully understood this document. Failure to follow the
directions and safety instructions could result in elec-
tric shocks, burns and/or serious injuries.
Keep this document in a safe place for future refer-
ence! These safety instructions must be accessible to
the operator at all times. They must be available to all
persons using or repairing the device.
2.2 Intended Use
The product is a part of the Cleco Production Tools Tight-
ening System and is intended exclusively for industrial use
in fastening processes. Only use the controller under the
following conditions:
•
in conjunction with the components listed in the EC
Declaration of Conformity.
•
under the prescribed environmental conditions; see
the relevant documentation
•
with the permissible supply voltage
•
within the power range, which is specified in the tech-
nical data
•
in EMC Limit Class A (electromagnetic immunity for
industrial areas). For the currently observed EMC
standards, see the EC Declaration of Conformity.
2.3 Predictable Misuse
Do not use the controller:
•
in potentially explosive areas
•
in damp spaces/outdoors
•
in connection with cutting tools (drills, milling cutters,
grinders...)
•
in the non-industrial sector (eg residential area)
•
for other drive tasks than screwing with the compo-
nents mentioned in the declaration of conformity.
•
for bridging of safety devices.
2.4 Operator Training
The tightening system may only be put into operation,
adjusted and tested by qualified and trained personnel.
The personnel must be instructed by qualified employees
of Apex Tool Group.
The controller has been preset by Apex Tool Group. Any
adjustment of the controller to accommodate special
requirements may only be carried out by a qualified per-
1)
son
.
Additional information can be found in the Programming
Manual.
1.) Due to their vocational training, knowledge, experience and
understanding of the circumstances involved in this kind of work,
suitably qualified personnel are able to identify potential hazards
and to initiate appropriate safety measures. Qualified personnel
are obliged to comply with regulations.
P2300HW | 2019-03
1
EN
1
5
Publicité
Table des Matières
