Troubleshooting - SilverCrest SEMK 105 A1 Mode D'emploi

Troubleshooting

Malfunction Cause
The plug is not inserted into a
mains power socket .
The appliance is
not working .
The appliance is defective .
There is not enough water in
the water tank .
The "Add water"
The water filter in the water
lamp
tank
lights up .
The pump is defective .
The ice basket
The "Ice full"
The infra red sensors above
lamp
the ice basket
lights up .
The infrared sensors above the
ice basket
The "Add water"
The ice cube tray in the rear
lamp and
part of the appliance is
the "Ice full"
blocked .
lamp
light up .
The water or ambient
temperature is too high .
No ice cubes
are produced .
The cooling system is leaky .
The cooling system is
blocked .
SEMK 105 A1
is blocked .
is full .
are dirty .
are defective .
Remedy
Connect the plug to the power supply .
Contact the Customer Service
department .
Fill the water tank as described in the
section "Filling the appliance" .
Remove any deposits or objects that are
blocking the water filter .
If necessary, you can remove the water filter
by pulling it straight upwards . Replace it
before using the appliance again .
To deal with stubborn deposits, proceed as
described in the section "Cleaning and care" .
Contact the Customer Service
department .
Remove some ice cubes from the ice
basket .
Clean the infra red sensors with a soft
cloth .
Contact the Customer Service
department .
Check whether the ice cube tray is
blocked, e .g . by an ice cube, and remove
the blockage .
Pull the plug from the mains socket and
plug it back in again, then restart the
appliance .
Make sure that the ambient temperature
♦
is no higher than 32°C .
Make sure that the water used is
♦
between 8 and 25°C .
Contact the Customer Service
department .
Contact the Customer Service
department .
GB │ IE │ 29 ■