Testeur De Résistance Du Sol; Battery Replacement - RS Pro ET-5300 Manuel D'instructions

Earth Resistance Tester/English
DC/AC VOLTAGE MEASUREMENTS
• Set the function switch to the highest 1000V DC (
• Insert the black test lead banana plug into the negative COM jack.
•Insert the red test lead banana plug into the positive V jack.
•Touch the black test probe tip to the negative side of the circuit.
•Touch the red test probe tip to the positive side of the circuit.
•Read the voltage in the display.
DC/AC VOLTAGE MEASUREMENTS: If the polarity is reversed, the display will show (-)
minus before the value
200k RESISTANCE MEASUREMENTS
• Set the function switch to the highest 200k position.
• Insert the black test lead banana plug into the negative COM jack
• Insert the red test lead banana plug into the positive
• Touch the test probe tips across the circuit or part under test. It is best to disconnect one
side of the part under test so the rest of the circuit will not interfere with the resistance
reading.
• Read the resistance in the display

Battery Replacement

• When the low battery symbol appears on the LCD, the six 1.5V 'AA' batteries must
be replaced.
• Turn the meter off and remove the test leads
• Unsnap the tilt stand from the rear of the meter
• Remove the four Phillips head screws holding the battery cover
• Remove the battery compartment cover
• Replace the batteries observing polarity
• Affix the rear cover and secure the screws.
• Reattach the tilt stand
6
) or 750VAV (~) position.
jack.
13/08/2017 Version No. 001
Manuel d'instructions
RS ET-5300
No d'inventaire: 144-5339
Testeur de résistance du sol
FR