Maintenance And Cleaning - Inventum VWM8001W Mode D'emploi

Acoustic signal volume can be set at four levels
• 0 means the sound is off;
• 1 means that the button sound is activated;
• 2 means low volume, and
• 3 means high volume.
Choose the volume level by rotating the programme selector knob to the left or to the right. The lowest setting means that
the acoustic signal is switched off.
5

maintenance and cleaning

WARNING!
Always unplug the appliance and close the water tap before cleaning and maintenance.
CLEANING THE EXTERIOR OF THE APPLIANCE
Proper maintenance of the appliance can extend its useful life. Clean the exterior of the appliance
and the control panel using a soft damp cloth and water. If necessary, a diluted non-abrasive
neutral cleaning agent can be used to clean the appliance.
i
CAUTION!
• Do not use abrasive or caustic agents, formic acids, diluted solvents or similar substances,
such as alcohol or chemical products that could damage the appliance. Please observe
the recommendations and warnings provided by the cleaning agent manufacturer.
• If there is any water overflow, use a cloth to wipe it off immediately.
• Do not clean the appliance with a jet of water.
• Do not use sharp items to clean the appliance.
CLEANING THE DRUM
Any rust stains left inside the drum by metal articles must be removed immediately using chlorine-free detergents. Do not
use steel wool for cleaning the drum!
i
NOTE!
• Do not keep laundry near the appliance while cleaning the drum.
• When you often wash at 40°C or lower temperatures, or when you haven't used the appliance for a longer period of time,
clean the drum. Run the Cotton programme at 90°C without laundry. Preferably use a powder detergent.
CLEANING THE RUBBER DOOR GASKET AND THE GLASS
Wipe the glass and rubber door gasket after each wash to remove lint and stains
and to extend the useful life of the appliance. If lint builds up, it can cause leakages.
Check the rubber door gasket to remove any coins, buttons or other objects after
each wash.
Clean the rubber door gasket and the glass once a month to ensure normal
operation of the appliance.
CLEANING THE INLET FILTER IN THE WATER TAP
i
NOTE!
• A diminishing water flow is a sign that the inlet filter needs to be cleaned.
• Cleaning the inlet filter every 3 months ensures normal operation of
the appliance.
1. Close the water tap and remove the water supply hose.
2. Clean the inlet filter with a brush under running water.
3. Reconnect the water supply hose to the water tap.
48
• English