Inventum VWM8001W Mode D'emploi page 47

PAUSING THE WASHING PROGRAMME (ADDING/REMOVING LAUNDRY)
The washing programme can always be stopped by pressing the Start/Pause button. The washing programme is
temporarily paused while the time remaining until programme completion is flashing on the display unit.
If the water level in the drum is below a certain value and the water temperature is not too high, the door will
unlock after a certain period of time. Open the door to add or remove laundry.
To resume the washing programme, first close the door and then press the Start/Pause button.
CANCELLING THE WASHING PROGRAMME
To stop and cancel a washing programme, press the On/Off/Reset button and hold it for more than 3 seconds.
Signal lights will flash on the display. At the same time, the washing machine pumps the water out of the washing
machine drum. When the water is pumped out, the washing machine door will be unlocked. If the water in the
washing machine is hot, the washing machine will automatically cool it and pump/drain it out.
END OF THE WASHING PROGRAMME
The washing machine will indicate the end of the washing programme with an acoustic signal and »End« will appear on
the display until the washing machine switches into low standby mode or switches off. After 5 minutes, the »End« sign will
no longer be displayed.
LOW STANDBY MODE
If you do not run any programme or choose any settings after switching on the washing machine (On/Off/Reset
button), the display unit will be switched off after 5 minutes and switched to standby mode in order to save energy.
The display unit will be reactivated if you rotate the programme selector knob or press the On/Off/Reset button.
If you do not do anything for 5 minutes after the end of a programme, the display unit will be switched off
to save power.
ERRORS
In case of an error or fault, the programme will be interrupted.
A flashing signal lights and an acoustic signal will warn about such an occurrence (see TROUBLESHOOTING TABLE),
and the error will be indicated on the display (E:XX).
POWER SUPPLY FAILURE
In case of a power supply failure, the washing programme is interrupted. When power supply resumes, »PF« (Power Failure)
will appear on the display unit. To resume the washing programme, press the Start/Pause button.
The delay time will not be reset.
Washing time will resume from the point at which the washing programme was interrupted.
PERSONAL SETTINGS
Basic or default settings for each washing programme can also be changed.
When you select the programme and additional functions, you may store such a combination by pressing the Start/Pause
button and holding it for five seconds. S C will appear on the display.
The programme will remain stored until it is changed using the same procedure. Personal settings can also be reset to factory
settings in the user menu.
PERSONAL SETTINGS MENU
Switch on the washing machine by pressing the On/Off/Reset button.
Simultaneously press Pre Wash [voorwas] and Start Delay [startuitstel] to open the Personal Settings Menu. Signal lights
for INTENSIVE [intensief], SHORT [kort], and EXTRA WATER (HIGH WATER LEVEL) will light up on the display unit.
Number 1 will appear on the LED display, which also indicates the settings function. Rotate the programme selector knob
to the left or to the right to choose the function to change.
Number 1 indicates sound settings and number 2 indicates resetting of Personal programme settings to factory defaults.
If the desired settings are not selected in 20 seconds, the programme will automatically return to the main menu.
Press the RPM [toeren] button (SPINNING RATE/DRAIN/PUMP STOP) to confirm the desired functions and their settings;
press Pre Wash [voorwas] to go back one step.
ADD LAUNDRY
RESET
3 sec
RESET
3 sec
47
English •