LEVELLING THE APPLIANCE
Use a water level and spanners No. 32 (for feet) and 17 (for the nut).
1. Level the washing machine in longitudinal and traverse
direction by screwing the adjustable feet up or down.
2. After adjusting the height of the feet, firmly tighten the jam
nuts (counter nuts) using a spanner No 17, by turning them
towards the bottom of the washing machine (see figure).
i
Incorrect levelling of the washing machine with the
adjustable legs may cause vibration, appliance moving across
the room, and loud operation.
Incorrect levelling of the washing machine is not subject to
warranty.
Sometimes, an unusual or louder noise may appear during
appliance operation; these are mostly the result of improper installation.
CONNECTING THE WATER SUPPLY HOSE
WARNING! To prevent leakage or water damage, follow the instructions in this chapter. Make sure not to kink, crush or
modify the water supply hose.
Tighten the water supply hose by hand, firmly enough for the hose to have a good seal. After connecting the hose, the
seal must be checked for any leaks. Do not use pliers or similar tools when connecting the water supply hose as this could
damage the nut thread.
1. Connect the water supply hose to the water inlet valve on
the back of the appliance.
2. Connect the other end of the water supply hose with the
aqua stop to a water tap with cold water.
CONNECTING THE WATER DISCHARGE HOSE
WARNING!
• Make sure not to kink or stretch the water discharge hose.
• Connect the water discharge hose properly, otherwise it could result in damage or water leakage.
Feed the water discharge hose into a drain pipe, wash basin or floor drain. Be careful not to feed the water discharge hose
too deep in the drain. Otherwise the waste water cannot flow freely. The vertical distance from the floor to the end of the
discharge hose may be no more than 100 cm and no less than 60 cm.
1. Put the water discharge hose in a floor drain.
2. Connect the water discharge hose to a drain pipe.
39
English
•