Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installing base unit
Hex wrench
Base unit
Spring washer
Hex wrench
Spring washer
Installing System Carrier (IN-XR)
Bolts (short)
(M6x15)
15mm
Arrow
Tighten further.
Installing Winter Carrier (TX ### )
Bolts (short)
(M6x15)
15mm
Tighten further.
Place the base unit on the installed
cushion base/base bracket, and using
the Hex wrench tighten alternately the
right and left bolts (short) [M6 x 15]
supplied with the carrier.
The base unit must be placed as the
arrow on the unit faces toward the
vehicle center.
●Tighten the bolt until the spring washer lies flat.
●Tighten the bolt with 4[N・m](40[kgf・cm]) of torque.
Place the carrier on the installed cushion
base/base bracket, and using the Hex
wrench, tighten alternately the right and
left bolts (short) [M6 x 15] supplied with
the carrier.
●Tighten the bolt until the spring washer lies flat.
●Tighten the bolt with 4[N・m](40[kgf・cm]) of torque.
EN-4
Publicité
Table des Matières
