Switching On The Appliance; Starting The Robot Mower - NOVARDEN NRL630 Mode D'emploi

EN

Switching on the appliance

Starting the robot mower

Once the robot mower is fully charged, you can start its mowing
cycle from:
• Its charging station.
• The start point selected in the mowing area within the perimeter
cable. This option is only valid if the robot mower remains on
since the last use.
If the robot mower has been switched off between uses, it must be
NOTE:
placed on its charging station before restarting it.
To manually start a mowing cycle:
• Switch on the robot mower. To do so, set the On/Off button to "I".
• Enter and confirm your PIN code. As a reminder, the default PIN
code is "0000". You can change it at any time via the control panel
(see page 6).
• Press the START button. The robot will then start its mowing
cycle.
To start an automatic mowing cycle (scheduling):
• Switch on the robot mower. To do so, set the On/Off button to "I".
• Enter your PIN code. As a reminder, the default PIN code is "0000".
You can change it at any time via the control panel (see page 7).
• Set the time (see page 7).
• Set the mowing area (see page 8).
• Set the robot mower's start time (see page 8).
Press the START button. The robot mower will start its mowing
•
cycle at the scheduled time.
10