Possible Causes - FORGE ADOUR PREMIUM 60 Mode D'emploi

"Troubleshooting" practical advice
ANOMALIES
Gas doesn't go
No spark when I light
my Plancha
The hose is not
connect to the plancha
Grease flow error
If despite the recommendations your problem persists, please contact your

POSSIBLE CAUSES

Empty gas cylinder
Defective regulator
Unprimed regulator
Regulator valve in
closed position
Defective battery
(depending on model)
Battery in wrong direction
Hose not approved
Hose connection direction is
incorrect
Hotplate tilt error
Grease pan positioning error
distributor.
SOLUTIONS
Change gas cylinder
Change the regulator
Prime the regulator
Open the regulator valve
Change the battery
Check the direction of the
battery
Replace the hose with an
approved model (see chapter
"gas connection").
Check the direction of the
hose
Adjust the inclination of the
hotplate using the adjusting
screws (depending on model).
Ensure that the Plancha or its
support are level.
Check the positioning of your
grease pan.
EN
23