FORGE ADOUR PREMIUM 60 Mode D'emploi page 19

Directions for use
LIGHTING AND OPERATION OF PLANCHA
Before lighting your plancha, check that all the
conditions stated in the "PRECAUTIONS
FOR USE" section are met.
•Check that the control switch si on the "0"
positioin as shown (Fig.1). Open the gas
supply
Control Switch
•Rotate the xontrol switch counterclockwise
while holding it down. (Fig.2)
Control Switch
•While still holdong the control switch
down, keep pressing on the ignition to
generate the sparks required for lighting of
the burners.
•Keep the control switch down for at least
5 seconds after lighting the burner. If the
burner has not ignited, stop acting on the
device, open the enclosure door and / or
wait at least 1 min before attempting to
light the burner again.
Positions of the control switch
P
OINT TO bE ChECkEd IN CASE OF mAlFUNCTION
No inflow of gas :
1. Check that the gas supply is open (bottle)
2. Check th contents of the gas bottle.
3. Check that the pressure relief valve
has been properly primed (refer to the instructions
provided by the relief valve manufacturer).
The burner does nit light up :
1. Piezzo starter failure or cable
disconnected.
2. Dirty burner or cloggerd injector.
3. Absence of gas or insifficient pressure.
The burner keeps going out :
1. Thermocouple failure or improperly
positioned.
2. Unsuitable weather conditions.
No spark on lighting :
1. Check the polarity of the battery and the
positioning of the spring. Replace the battery.
Stop
EN
High flame
Low flame -
Lighting
:
19