Operation; Mode Of Operation; Maintenance And Environmental Protection - Meister PS600M Traduction Du Manuel D'utilisation Original

rubber seal, firmly into the guide groove
of the extraction opening and fix with a
gentle turn. The drawn down cutting pro-
tection element (10) will improve the effi-
ciency of the dust removal process.
Mitre/bevelled cuts
The saw shoe (5) is set to the
middle position (O°) when the
machine leaves the factory. To
set it for mitre or bevelled cuts, loosen
the holding screw of the shoe with the
adjustment wrench (Figure 3) and push
the shoe forwards from the rest position.
Set the cutting angle (6) by turning the to
the right or left. The angles 0°, 15°, 30°
and 45° are marked but intermediate val-
ues may also be selected. Tighten the
holding screw up again. When carrying
out cuts at an angle, push the cutting
protection element (10) up as far as it
will go.
8 – Operation
Insert mains plug into an outlet
• ON: Press on/off switch (1) and hold.
• OFF: Release on/off switch (1).
• Continuous operation ON: Press on/
off switch (1), actuate lock knob (2)
and lock in place.
• Continuous operation OFF: Press
switch (1) again - lock knob jumps out
of locking device and release.
40
5403120-Pendelhubstichsaege_man.indd 40 5403120-Pendelhubstichsaege_man.indd 40
9 – Mode of operation
Sawing
Do not force the saw; this causes the
saw blade to overheat and bend and/or
break. If material to be cut is thin, place
it on an additional board/plate to damp-
en vibrations and improve cutting.
Drop sawing
If the workpiece is to be sawn in the
middle and holes cannot be bored in it,
set the oscillation to 0, loosen the foot-
plate, push it back and lock it. Hold the
machine at an angle and carefully allow
the blade to slide on to the workpiece
(Fig. 5). As soon as the workpiece is
sawn through, continue working with the
machine in the normal position.
10 – Maintenance and envi-
ronmental protection
Regularly dust sawdust off housings,
ventilation openings and movable parts.
Where applicable, wipe off with a damp
cloth. Do not drop electrical machines in
water. Apply a light coat off oil to saw
blade guide roller from time to time.
CAUTION! Electrical and battery
operated units that no longer
work should not be disposed of in the
household waste! They are to be col-
lected separately, in accordance with
the 2012/19/EU directive for the dis-
posal of electrical and
electronic waste, and
sent for proper and
environ mentally-friendly
recycling.
17.07.20 06:58 17.07.20 06:58