Special Settings - Becker BOM 520 Instructions D'utilisation

BOM 520/820 Operating Instructions
F =
21

Special settings

Menu step 7: Lighting times
Keep the button pressed down for 3 seconds. The number 3 appears in the display. Press the
until menu step 6 is displayed. Keep the
Menu Lighting time
0 60s
1 90s
2 120s
3 240s
4 0s
5 90s
6 240s
7 0s
8 90s
9 240s
If the warning time is set, the light will flash before the drive starts and during movement. The factory setting is 1.
Menu step 8: Soft run sections
Note
The factory setting of 4 must be retained. Any change in the soft run sections requires the express approval of
the door manufacturer. Press
Press button. Number 8 appears on the display.
Menu value Start Up
0 0
1 15
2 0
3 15
4 25
5 15
6 15
7 35
8 60
9
This data correspond to the soft run sections measured on the running slide block in cm.
15
kg
1 sec.
button pressed down for another 3 seconds until number 7 appears.
Warning time
-
-
-
-
3s
3s
3s
10s
10s
10s
button. The number 0 appears on the display.
Stop Up Start Down
0 0
0 15
15 0
15 15
45 25
15 15
15 15
35 35
15 15
soft run only
Fig. 21 - Checking the power limitation
device
- Position obstacle (e.g. drive box) beneath the
door's closing edge.
- Start door from the UP end position.
a
- Drive contacts the obstacle and stops, then re-
turns to the top end position.
- Point display (a) must switch off for approx. 1
second. The drive will then operate fault-free.
If springs have been changed on the door, then a
new power programming run must be carried out:
Go to menu step 5 and keep the
down for 3 seconds. The number 0 will appear. Then
carry out power programming run as explained in
point 18a.
Stop Down
0
0
60
35
45
60
15
50
85
button pressed
button several times,
25