Quality Espresso Steam Cube Mode D'emploi page 33

Electrical

connection



Manipulation 



Check that all of the electrical connection characteristics comply with
the voltage, frequency and wattage indications described on the
Dispenser's specification plate. This plate is located on the chassis
under the drainage tray.
We consider the Dispenser to be installed correctly when it has been
connected to a magneto-thermic
appropriate to the Dispenser's power, along with a differential that
does not exceed a residual current of 30 mA.
The Dispenser must be installed in accordance with the current
electrical regulations of your area. You must make sure that the
electrical installation is reliably grounded in accordance with the
aforementioned regulations. The company declines any liability for
possible injuries caused by a defective installation or incorrect
ground connection.
Extension cables or outlet adapters of any kind should not be used to
connect the Dispenser to the power supply. The connection cables
should never be rolled up, but instead it should be fully extended to
avoid possible overheating.
Any internal manipulation of the dispenser, except that which is
specifically described in this manual regarding cleaning processes,
must be performed by an authorized service technician.
Cleaning and preventive maintenance according to the frequency
indicated for the machine, or by the service technician, is required.
The manufacturer declines any responsibility for possible damage to
the machine due to non-compliance with these requirements, as well
as damage due to the incorrect or inappropriate use of the machine.
All machine components, including the electrical connection cable,
should only be replaced by original parts. If the electrical connection
cable is damaged, it should be replaced by the manufacturer, a
service technician, or by similarly qualified personnel so as to avoid
any danger.
Before proceeding with any maintenance operations, disconnect the
dispenser from the electrical supply either through the mains general
switch or by disconnecting the power cable.
omnipolar
30
circuit breaker
EN