Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Hz AC electrical supply on a separate
circuit fused in both sides of the line. A
circuit breaker or time delay fuse sized
not to exceed the circuit rating of the
appliance specified on the rating plate
located on the frame behind the door
of the oven is recommended.
The oven must be supplied with copper
or aluminum wires.
If aluminum wire is provided to
connect oven to branch circuit, UL
listed connectors for joining copper
and aluminum must be used. Follow
instructions provided with connectors.
If is recommended that you have the
electrical wiring and hook-up of your
oven performed by a qulified electrician.
After installation is complete have the
electrician show you where the main
disconnect is and which of the circuit
breakers/fuses are for the oven.
Choosing oven location
Carefully select the location where the
oven will be placed.
The oven should be located for
convenient use in the kitchen, but away
from strong drafts.
Strong drafts may be caused by open
doors or windows, or by heating and/
or air conditioning vents or fans. Make
sure that electrical power can be
provided to the location selected.
Steps for installation
The following pages provided the
necessary
installation of the oven and are
arranged as follows:
•
Technical Data
•
Installation
Required
Mounting instructions for:
- Under counter installation, Single
Oven
- Wall installation, Single Oven
•
Electrical
Requirments,
required if connecting to 120/208
Volt Circuit. Electrical Connections
for 3-wire or 4-wire Branch Circuit.
•
Final Checklist.
15
15
information
for
Cutout
Dimensions,
Clearances
supply
and
Programming
proper
GB
and
Wiring
Publicité
Table des Matières
