Dyna-Glo DGP321SNP Mode D'emploi page 12

ASSEMBLY INSTRUCTIONS
11. Carefully place the grill body (C) onto cart left
side panel assembly (L) and cart right side
panel assembly (G). Adjust the grill body (C)
so that the holes in the grill body (C) are
aligned with holes in the tabs of cart left side
panel assembly (L) and cart right side panel
assembly (G).
Note: Make sure the gas hose/regulator
assembly is inside the cart. Secure the grill
body (C) with four M6X16 bolts (AA).
Hardware Used
AA
M6x16 Bolt
12. Pre-assemble two M6x16 bolts (AA) onto the
cart right side panel assembly (G) and do not
tighten them. Make sure to leave a 5mm
gap between the bolt and the panel. Then
hang the regulator assembly bracket onto the
bolts and tighten the two bolts.
Hardware Used
AA
M6x16 Bolt
Hardware Used
AA AA
M6x16 Bolt
x 4
Hardware Used
AA AA
M6x16 Bolt x2
x 2
12
11
x4
12
C
C
AA
AA
G
5mm
G