Black & Decker BXAC12000E Manuel D'utilisation page 8

ENGLISH
Cooling function:
♦ Press the button MODE until the word Cool appear on
the control panel.
♦ Press the up or down button to increase or decrease the
temperature.
♦ Under cooling mode, the setting temperature ranges
from 16~30°C.
♦ NOTE: If the temperature of the room is higher of the
selected one, the appliance will not start working.
Fan function:
♦ Press the button MODE until the word Fan appear on
the control panel.
♦ You can choose the speed fan: Low-middle-high.
Heat function:
♦ Press mode (A2/ 2) to select heat mode, the Heat mode
indicator will light.
♦ Press (A7/ 6) to adjust the temperature.
♦ Press speed (A3/ 3) to increase or decrease speed.
Dehumidifying function:
♦ Press the button MODE until the word Dry appear on the
control panel
♦ On the dehumidifying mode, the fan is working in low
speed.
♦ Anti-freezing protection control (only for the model
BXAC12000E):
♦ Under anti freezing function,the heat light will flash
♦ Anti-heating protecting (only for the model BX-
AC12000E):
♦ Under heating mode, the compressor and motor will stop
work until the temperature of the machine automatically
recover to ordinary heating status.
Compressor delay-protection
♦ Except for the first power-on, the compressor can start
at once. In other cases, the compressor runs under 3
minutes delay protection.
Water tank full protection:
♦ When the water level in the bottom water plate is above
the warning level, the unit will alert automatically and
"FL" will flashes on LCD.
♦ Please discharge water in the machine according to
chapter "water drainage".
8
(Original instructions)
Stand-by function:
♦ In order to save energy, the appliance passes to stand-
by after 10 seconds if the user does not use it.
♦ To turn it on again, you simply have to press the on/off
button.
♦ Once you have finished using the appliance:
♦ Stop the appliance by pressing the on/off button.
♦ Unplug the appliance from the mains.
♦ Remove the water from the water tank.
♦ Clean the appliance.
Carry handle/s:
♦ This appliance has a handle on the side of the body,
which facilitates comfortable transport.
Water drainage:
Manual drainage:
♦ When the water tank is full and unit stop working, please
shut off the unit and unplug .
♦ Do not move the model sharply, or the water will split out
from water received plate.
♦ Use a container to drain the water from the drain plug.
♦ Screw off the water plug and unplug the water blocker,
water will come out the water container.
♦ When finished , replace the water blocker and screw on
the water plug.
Continuous drainage:
♦ Screw off the water plug and unplug the water blocker.
♦ Use water pipe to connect the water outlet. Lead the
pipe to the outside or washroom.
♦ NOTE: This method can be done only if there is no water
in the water received plate.
♦ This model have self evaporative function, under cooling
mode, please do not use continue drainage to get better
cooling effect.
Air filter cleaning:
♦ Clean the air filters every 2 weeks. If the air filter is
blocked with dust, the efficiency will reduce.
♦ Pull out up and down filter.
♦ Wash the air filters by immersing it gently into warm wa-
ter with a neutral detergent, rinse it and dry it thoroughly
in a shaded place.
♦ Install air filters carefully after cleaning the filters.